Table of Contents
Advertisement
dot1x timeout keep-unauth
dot1x timeout keep-unauth
Sets the period of time (in seconds) for maintaining the communication-disabled state of the
interface if two or more terminals are connected to an interface on which the single-mode
authentication submode is set. After the time set by using this command elapses, an
authenticated terminal must be re-authenticated.
Input format
To set or change information:
dot1x timeout keep-unauth
To delete information:
no dot1x timeout keep-unauth
Input mode
(config-if)
Parameters
<Seconds>
Sets the period of time (in seconds) for maintaining the communication-disabled state
when single mode is set as authentication submode.
1.
2.
Default behavior
3600 seconds is used as the period of time for maintaining the communication-disabled
state.
Impact on communication
None
When the change is applied
When the communication becomes impossible.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
The
port-control
4.
The value set for this command is applied only to an interface in single-mode
authentication submode.
400
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
dot1x timeout tx-period
command has been set.
<Seconds>
dot1x system-auth-control
command takes effect only if the
dot1x
Advertisement
Table of Contents
