Table of Contents
Advertisement
logging host
Sets the output destination of the log information. A maximum of four entries can be
configured.
Input format
To set or change information:
logging host
To delete information:
no logging host
Input mode
(config)
Parameters
<IP address>
Sets the IPv4 address of the logging destination.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
To use the syslog functionality, a syslog daemon program must be running on the
destination host and the host must be configured so that it can receive the syslog
information from the Switch.
2.
127.*.*.*
Related commands
None
<IP address>
<IP address>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
<IP address>
Set the IPv4 address in dot notation.
1.0.0.0 to 126.255.255.255, 128.0.0.0 to 223.255.255.255
cannot be specified as an IPv4 address.
logging host
643
Advertisement
Table of Contents
