Spanning-Tree Single Pathcost Method - Alaxala AX1250S Software Manual

spanning-tree single pathcost method

Sets whether to use a 16-bit value or a 32-bit value as the path cost for single-spanning-tree
ports.
If the spanning-tree single cost
applied to the path cost according to the interface speed and the setting of the
spanning-tree single pathcost method

If short
For 10 Mbit/s: 100
For 100 Mbit/s: 19
For 1 Gbit/s: 4

If
long
For 10 Mbit/s: 2000000
For 100 Mbit/s: 200000
For 1 Gbit/s: 20000
Input format
To set or change information:
spanning-tree single pathcost method { long | short }
To delete information:
no spanning-tree single pathcost method
Input mode
(config)
Parameters
{ long | short }
If
long
1.
2.
3.
Default behavior
The setting of the
is set for the spanning-tree single pathcost method
is set for the
spanning-tree single pathcost method
is set, a 32-bit value is used. If
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
long or short
Notes on using this parameter:
- The default value of the path cost changes.
- Changing the path cost value might change the topology.
- When 65536 or a larger value is set for the path cost, you cannot change the
parameter to short .
spanning-tree pathcost method
command setting is omitted, the following values are
command.
is set, a 16-bit value is used.
short
command is used.
spanning-tree single pathcost method
command:
command:
189