Table of Contents
Advertisement
web-authentication vlan
web-authentication vlan
Sets the VLAN ID to dynamically switch after user authentication.
Unless this command is set, no VLANs can be switched after authentication.
Input format
To set or change information:
web-authentication vlan
To delete information:
no web-authentication vlan
Input mode
(config)
Parameters
<VLAN ID list>
Sets the VLAN ID list of MAC VLANs that can be switched after user authentication.
1.
2.
Default behavior
No VLANs are switched after authentication.
Impact on communication
If a VLAN is deleted by using this command, users registered in the deleted VLAN are
logged out.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
All VLAN IDs you have set must be set for a MAC VLAN.
4.
If at least one of the following commands is set for a Switch, this command cannot be
set:
492
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For details about how to set
Specifiable values for parameters. Note that the default VLAN (
cannot be set.
command is set.
authentication multi-step
<VLAN ID list>
<VLAN ID list>
<VLAN ID list>
and the specifiable values, see
VLAN ID = 1
web-authentication
)
Advertisement
Table of Contents
