Table of Contents
Advertisement
spanning-tree mst cost
spanning-tree mst cost
Sets the path cost for the applicable multiple-spanning-tree ports.
Input format
To set or change information:
spanning-tree mst
To delete information:
no spanning-tree mst
Input mode
(config-if)
Parameters
<MSTI ID list>
Sets an MST instance ID. One MST instance ID can be set. You can use a hyphen (
or a comma (
1.
2.
<Cost>
Specify the path cost value. The lower the
the port will be used for forwarding the applicable frames.
1.
2.
3.
Default behavior
The setting of the
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
164
<MSTI ID list>
<MSTI ID list>
,
) to set multiple MST instance IDs at one time.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 4095
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 200000000
Notes on using this parameter:
Changing the path cost value might change the topology.
spanning-tree cost
cost
<Cost>
cost
<Cost>
value, the higher the possibility that
command is used.
-
)
Advertisement
Table of Contents
