Table of Contents
Advertisement
channel-group mode
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
To change static link aggregation to LACP-based link aggregation, or vice versa,
delete this command, change the mode, and then set the command again.
2.
When
channel group is automatically generated. If
specific operation is required.
3.
If the
when you set this command, you must either specify the same setting for the
applicable interface and the port channel interface with the specified channel group
number or else do not set a common configuration command for the applicable
interface. For details, see 13.2.4 Configuration of a port channel interface in
Configuration Guide Vol. 1.
4.
If you want to delete this command, do so after executing the
the applicable interface.
5.
Deleting this command does not delete the
of all ports in a channel group does not delete the
When deleting a channel group, you must delete the
manually.
Related commands
interface fastethernet
interface gigabitethernet
106
channel-group mode
port-channel
setting of the specified channel group number already exists
is set, the
port-channel
port-channel
port-channel
port-channel
setting of the specified
has already been set, no
command for
shutdown
configuration (the deletion
configuration).
port-channel
configuration
Advertisement
Table of Contents
