Table of Contents
Advertisement
1 to 30 (seconds)
retransmit
<Retries>
Sets the number of times an authentication request is resent to the RADIUS server.
1.
Default value when this parameter is omitted:
The number of times set by using the
is used. If no value is set, the initial value is 3.
2.
Range of values:
0 to 15 (times)
key
<String>
Sets the RADIUS key used for encryption or for authentication of communication with
the RADIUS server. The same RADIUS key must be set for the client and the
RADIUS server.
1.
Default value when this parameter is omitted:
The RADIUS key set by using the
key is set, the RADIUS server is disabled.
2.
Range of values:
Specify a character string that is no more than 64 characters. For details about
the characters that can be specified, see Specifiable values for parameters.
Default behavior
The RADIUS server settings registered by using the
used.
If the
radius-server host
using the internal Web authentication database without using the RADIUS server.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
When this command is set, the setting information of the RADIUS server referenced
by Web authentication has precedence over the information set by the
radius-server host
are not applied). For details about the settings of the general RADIUS server
information and the Web authentication RADIUS server information, see the
Configuration Guide Vol. 2.
4.
A maximum of four Web authentication RADIUS servers can be specified for each
Switch.
5.
127.*.*.*
command is not registered, user authentication is performed by
command is set.
command (the settings of the
cannot be specified as an IPv4 address.
web-authentication radius-server host
radius-server retransmit
radius-server key
command is used. If no
radius-server host
web-authentication
radius-server host
command
command are
command
471
Advertisement
Table of Contents
