Spanning-Tree Vlan Forward-Time - Alaxala AX1250S Software Manual

spanning-tree vlan forward-time

Sets the time required for PVST+ state transition.
Input format
To set or change information:
spanning-tree vlan
To delete information:
no spanning-tree vlan
Input mode
(config)
Parameters
<VLAN ID list>
Starts configuration of PVST+ for the specified VLAN.
1.
2.
<Seconds>
Specify the time in seconds required for the state of a port to change.
If pvst
vlan
maintained for the set period of time.
If rapid-pvst
spanning-tree vlan
learning state are maintained for the set period of time (note that this applies only
when the timer causes the transition).
1.
2.
Default behavior
15 seconds is set as the time required for the state of a port to change.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
<VLAN ID list>
<VLAN ID list>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For details about how to set
Specifiable values for parameters.
(802.1D) is set for the
<VLAN ID list> mode command, the listening state and the learning state are
(802.1w) is set for the
<VLAN ID list>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
4 to 30 (seconds)
forward-time
forward-time
<VLAN ID list> and the specifiable values, see
spanning-tree mode command or the
spanning-tree mode
mode command, the discarding state and the
spanning-tree vlan forward-time
<Seconds>
spanning-tree
command or the
197