Storm-Control - Alaxala AX1250S Software Manual

storm-control

storm-control
Configures the storm control functionality. This functionality sets the threshold of frames to
be flooded and received by a Switch. When a broadcast storm or another problem occurs,
the flooded frames exceeding the threshold are discarded. As a result, network load and
Switch load decrease.
The following are specifiable when storm control is used:

A storm detection threshold (upper threshold), recovery-from-storm threshold, and
flow rate limit value (lower threshold) specified as a number of received frames

Deactivating the target port or limiting the flow rate of received frames

A monitoring time for canceling the flow rate limit

Issuing SNMP traps or outputting an operation log data
Input format
To set or change information:
storm-control broadcast level pps
storm-control multicast level pps
storm-control unicast level pps
storm-control action { inactivate | filter }
storm-control action trap
storm-control action log
storm-control filter-broadcast
storm-control filter-multicast
storm-control filter-unicast
storm-control filter-recovery-time
To delete information:
no storm-control broadcast
no storm-control multicast
no storm-control unicast
no storm-control action { inactivate | filter }
no storm-control action trap
no storm-control action log
no storm-control filter-broadcast
no storm-control filter-multicast
no storm-control filter-unicast
no storm-control filter-recovery-time
Input mode
(config-if)
580
<Packet/s 1> [
<Packet/s 1> [
<Packet/s 1> [ <Packet/s 2>
<Packet/s>
<Packet/s>
<Packet/s>
<Seconds>
<Packet/s 2> ]
<Packet/s 2> ]
]