Ip Access-List Resequence - Alaxala AX1250S Software Manual

ip access-list resequence

Resets the sequence numbers of the sequence in which filter conditions are applied in IPv4
address filtering or IPv4 packet filtering.
Input format
To set or change information:
ip access-list resequence
Input mode
(config)
Parameters
<ACL ID>
Specify the identifier of the IPv4 address filter or the IPv4 packet filter that is to be set.
1.
2.
<Starting seq>
Specify the starting sequence number.
1.
2.
<Increment seq>
Sets the increment value for the sequence.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
Default value when this parameter is omitted:
The initial value is 10.
Range of values:
Set 1 to 4294967295 (in decimal).
Default value when this parameter is omitted:
The initial value is 10.
Range of values:
Set 1 to 100 (in decimal).
<ACL ID> [ <Starting seq>
ip access-list resequence
[ <Increment seq> ]]
295