Table of Contents
Advertisement
qos-queue-group
Sets QoS queue list information for an interface (physical port).
Input format
To set information:
qos-queue-group
To delete information:
no qos-queue-group
Input mode
(config-if)
Parameters
<QoS queue list name>
Specify the QoS queue list name.
1.
2.
Default behavior
is set as the scheduling mode.
PQ
Impact on communication
If the scheduling mode is changed by setting the QoS queue list name, the applicable line
restarts, causing communication on the line stop temporarily.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the scheduling mode is changed by setting a QoS queue list name, the new
interface (a physical port) restarts. If queued packets remain in the send queue when
changes are made, all packets are removed from the queue. While the packets are
being removed from the queue, no new packets can be queued. You need to be
careful if you logged in via a network.
2.
If you did not set the scheduling mode by setting the QoS queue list name,
as the scheduling mode.
3.
If an invalid queue list name is set by using the
used as the scheduling mode.
<QoS queue list name>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
qos-queue-group
command,
qos-queue-group
PQ
is set
PQ
is
349
Advertisement
Table of Contents
