Table of Contents
Advertisement
forwarding-shift-time
forwarding-shift-time
Sets the reception hold time for flush control frames in transit node.
When the reception hold time passes, if no flush control frames are received, the status of a
ring port changes from
Input format
To set information:
forwarding-shift-time {
To delete information:
no forwarding-shift-time
Input mode
(config-axrp)
Parameters
<Seconds>
{
Sets the reception hold time for flush control frames in seconds.
If you set
on the transit node does not switch to
received.
1.
2.
Default behavior
10 seconds is used as the reception hold time for flush control frames.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the sending interval for health check frames on the master node is longer than the
reception hold time for flush control frames on the transit node, the status of the ring
port on the transit node switches to
normal state. This could produce a temporary loop.
Set a hold time value in consideration of the interval for sending health check frames
from the master node.
222
Blocking
to
<Seconds>
| infinity}
infinity
, there is no limit on the hold time, and the status of the ring port
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds) or
Forwarding
.
| infinity}
Forwarding
until a flush control frame is
infinity
Forwarding
before the master node detects a
Advertisement
Table of Contents
