Table of Contents
Advertisement
web-authentication html-fileset
Sets a custom file name for the Web authentication page displayed for each port.
Input format
To set or change information:
web-authentication html-fileset
To delete information:
no web-authentication html-fileset
Input mode
(config-if)
Parameters
<Name>
Specify the custom file set name registered on the Switch by using the
web-authentication html-files
1.
2.
Default behavior
The basic Web authentication page is displayed when a user logs in.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
To set the
web-authentication port
4.
This command can be set only for Ethernet interfaces.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a character string that is no more than 16 characters. Specifiable
characters are upper-case alphanumeric characters.
command is set.
web-authentication html-fileset
command for the applicable port in advance.
web-authentication html-fileset
<Name>
operation command.
web-authentication
command, set the
set
443
Advertisement
Table of Contents
