Table of Contents
Advertisement
switchport-backup startup-active-port-selection
Enables active port locking at Switch startup.
Input format
To set information:
switchport-backup startup-active-port-selection primary-only
To delete information:
no switchport-backup startup-active-port-selection
Input mode
(config)
Parameters
primary-only
Sets only the primary port as the active port at Switch startup.
1.
2.
Default behavior
The secondary port can also be selected as the active port at Switch startup.
Impact on communication
None
When the change is applied
The change is operational as soon as the setting value is changed and every time the
Switch starts.
Notes
1.
Even when this configuration has been deleted, the uplink port on which the active
port locking functionality at Switch startup is operating enters a state in which no
active ports are set until link-up occurs on the primary port.
2.
On the uplink port on which the active port locking functionality at Switch startup is
operating, the active port locking functionality is released if the following conditions
exist:
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
primary-only
Link-up occurs on the primary port.
Execution of the
select switchport backup interface
makes the secondary port the active port.
switchport-backup startup-active-port-selection
operation command
573
Advertisement
Table of Contents
