Web-Authentication Ip Address - Alaxala AX1250S Software Manual

web-authentication ip address

Configure an IP address and a domain name to be used exclusively for Web authentication.
Setting a dedicated IP address by using this command allows you to log in from and log out
from an authenticated terminal by using the same IP address on the Switch.
Input format
To set or change information:
web-authentication ip address
To delete information:
no web-authentication ip address
Input mode
(config)
Parameters
<IP address>
Sets an IP address to be used exclusively for Web authentication.
1.
2.
fqdn <FQDN>
Use a fully qualified domain name (FQDN) for the domain name.
1.
2.
Default behavior
The IP address of an pre-authentication VLAN is used.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Sets the IPv4 address (dot notation).
1.0.0.0 to 126.255.255.255, 128.0.0.0 to 223.255.255.255
IP address of a subnet that does not overlap a VLAN interface set for the
Switch
Default value when this parameter is omitted:
Only <IP address> is used.
Range of values:
Specify a character string that is no more than 256 characters. For details
about the characters that can be specified, see Specifiable values for
parameters.
<IP address> [fqdn <FQDN>
web-authentication ip address
]
445