Table of Contents
Advertisement
None
syn
Sets detection of packets whose SYN flag in the TCP header is 1.
This parameter is an option available only when the protocol is TCP.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
None
urg
Sets detection of packets whose URG flag in the TCP header is 1.
This parameter is an option available only when the protocol is TCP.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
None
vlan
<VLAN ID>
Sets the VLAN ID.
This parameter is effective only when it is applied to an Ethernet interface.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
See Specifiable values for parameters.
user-priority
Sets the user priority.
1.
Default value when this parameter is omitted:
None. (The parameter is not set as a detection condition.)
2.
Range of values:
Set 0 to 7 (in decimal).
Default behavior
None
Impact on communication
If any entry is added when an access list with no entries set is being applied to an interface,
the IP packets received on the applicable interface are discarded temporarily until the entry
is applied to the interface.
When the change is applied
The change is applied immediately after setting values are changed.
<Priority>
permit (ip access-list extended)
309
Advertisement
Table of Contents
