Dot1X System-Auth-Control - Alaxala AX1250S Software Manual

dot1x system-auth-control

Enables IEEE 802.1X.
Input format
To set information:
dot1x system-auth-control
To delete information:
no dot1x system-auth-control
Input mode
(config)
Parameters
None
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
2. If the EAPOL forwarding functionality has been set, this command fails and IEEE
802.1X is not enabled.
3. If the
cannot be used for IEEE 802.1X authentication.
Related commands
l2protocol-tunnel eap
aaa authentication dot1x
aaa authentication dot1x
command has not been set, a RADIUS server
dot1x system-auth-control
399