36.1.16 Flow Detection Mode Information; 36.1.17 Access List Information - Alaxala AX1250S Software Manual

Index

36.1.16 Flow detection mode information

Table 36-16 Flow mode error messages
Message
Cannot change the flow detection
mode.

36.1.17 Access list information

Table 36-17 Access list error messages
Message
Cannot attach this list because
flow detection mode Layer2-1.
Cannot attach this list because
flow detection mode Layer2-2.
Maximum number of entries are
already defined.
<value1>
Over two entry as an address
family cannot be set.
system function isn't set.
The sequence number exceeded the
maximum value. Try "resequence"
Command.
This list cannot be set to this
port.
672
Explanation
The flow detection mode cannot be changed because an access list
or a QoS flow list is applied to the interface.
To change the flow detection mode, delete all uses of the applied
lists.
Explanation
If the flow detection mode is Layer 2-1, the access list cannot be
applied.
If the flow detection mode is Layer 2-1, a MAC access list can be
applied.
To do so, use the following command:
mac access-group
command
If the flow detection mode is Layer 2-2, the access list cannot be
applied.
If the flow detection mode is Layer 2-2, an IPv4 access list can be
applied.
To do so, use the following command:
ip access-group
command
The entry cannot be added because the maximum number of entries
has already been reached. Delete unnecessary entries, and then
add the new entry.
Another access list has already been applied.
If you want to apply the access list, first delete an existing access
list.
The setting is not possible because the
command has not been set.
system function
Use the
The automatic sequence number exceeds the maximum value.
resequence
Execute the
The access list cannot be applied to the applicable Ethernet
interface.
When an access list is applied to an Ethernet interface, the VLAN ID
of a flow detection condition in the access list must be included in the
settings of the Ethernet interface to which you want to apply the
system function
command to specify a filter.
command.