Control-Packet User-Priority - Alaxala AX1250S Software Manual

control-packet user-priority

control-packet user-priority
Sets the user priority in the VLAN tags of frames spontaneously sent by a Switch. If this
command is not set or if information is deleted, 7 is used as the user priority of frames
spontaneously sent.
Input format
To set or change information:
control-packet user-priority { layer-2
priority>
To delete information:
no control-packet user-priority
Input mode
(config)
Parameters
{ layer-2
<User priority>
Sets the user priority of frames spontaneously sent by a Switch.
1.
2.
Default behavior
7 is used as the user priority of frames spontaneously sent by a Switch.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None
358
<User priority>
| layer-2
<User priority>
| layer-3
}
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set a value from 0 to 7. 7 is used as the user priority if no value is set.
<User priority>
<User priority>
layer-3
<User priority>
| layer-2
| layer-3 <User
}
<User priority>
layer-3