Mac-Authentication Port - Alaxala AX1250S Software Manual

mac-authentication port

mac-authentication port
Sets the authentication mode for ports.
Input format
To set information:
mac-authentication port
To delete information:
no mac-authentication port
Input mode
(config-if)
Parameters
None
Default behavior
When MAC-based authentication is valid, the port operates in legacy mode.
Impact on communication
If a port subject to authentication is deleted by using this command, authentication is
canceled on all applicable ports.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the
system-auth-control
2. See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3. If extended-authentication
was set, this command cannot be set. (This command can be set if the
function
4. This command can be set only for Ethernet interfaces.
Related commands
mac-authentication system-auth-control
authentication ip access-group
authentication arp-relay
534
command is set.
was not set when the
command was not set.)
mac-authentication
system function command
system