Table of Contents
Advertisement
spanning-tree single cost
Sets the path cost for the applicable single-spanning-tree ports.
Input format
To set or change information:
spanning-tree single cost
To delete information:
no spanning-tree single cost
Input mode
(config-if)
Parameters
<Cost>
Specify the path cost value. The lower the
the port will be used for forwarding the applicable frames.
1.
2.
3.
Default behavior
The path cost is applied according to the setting of the
method
command.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
When
short
is set for the
spanning-tree single pathcost method
1 to 65535
When
long
is set for the
spanning-tree single pathcost method
1 to 200000000
Notes on using this parameter:
Changing the path cost value might change the topology.
<Cost>
<Cost>
value, the higher the possibility that
spanning-tree pathcost method
command:
spanning-tree pathcost method
command:
spanning-tree single pathcost
spanning-tree single cost
or the
or the
183
Advertisement
Table of Contents
