Table of Contents
Advertisement
authentication multi-step
authentication multi-step
Configure a multistep authentication port.
Input format
To set or change information:
authentication multi-step
To delete information:
no authentication multi-step
Input mode
(config-if)
Parameters
{permissive | dot1x}
permissive
dot1x
Default behavior
The port operates as a single authentication port.
Impact on communication
The authenticated state of a terminal connected to the applicable port is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
560
Permits both Web authentication and IEEE 802.1X authentication for a
terminal on which the first step (MAC-based authentication) has failed.
1.
Default value when this parameter is omitted:
For a terminal on which the first step (MAC-based authentication) has
failed, neither Web authentication nor IEEE 802.1X authentication is
permitted.
Permits MAC-based authentication and IEEE 802.1X authentication as the first
step of authentication. For a terminal on which the first step (MAC-based
authentication or IEEE 802.1X authentication) has failed, Web authentication
is not permitted.
1.
Default value when this parameter is omitted:
For a terminal on which the first step (MAC-based authentication) has
failed, neither Web authentication nor IEEE 802.1X authentication is
permitted.
2.
Range of values:
permissive
or
dot1x
[{permissive | dot1x}]
Advertisement
Table of Contents
