radius-server dead-interval
Notes
1.
If more than three general RADIUS servers are configured and another general
RADIUS server becomes the current server after the monitoring timer starts, the
monitoring timer is not reset and continues to run.
2.
In general, when the monitoring timer has started, it does not reset until it expires.
However, as exceptions, it resets in the following cases:
3.
If the monitoring timer expires while the authentication sequence is being executed
on the terminal subject to authentication, restoration of the primary general RADIUS
server is not performed until the executed authentication sequence has been
completed.
Related commands
aaa authentication
radius-server host
radius-server key
radius-server retransmit
radius-server timeout
28
When
radius-server dead-interval 0
When information about the general RADIUS server running as the current
server is deleted by using the
When the
clear radius-server
is configured by using this command.
radius-server host
command
operation command is executed