Table of Contents
Advertisement
lacp system-priority
lacp system-priority
Sets the effective LACP system priority for a Switch.
Input format
To set or change information:
lacp system-priority
To delete information:
no lacp system-priority
Input mode
(config)
Parameters
<Priority>
Sets the LACP system priority. The lower the priority value, the higher the priority.
1.
2.
Default behavior
If the
channel-group lacp system-priority
If the
channel-group lacp system-priority
Impact on communication
If a priority is set for the operating channel group, the channel group goes down, and then
restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
This command is effective only when LCAP-based link aggregation is used.
2.
If the LACP system priority is changed, the status of all ports registered for the
channel changes to
Related commands
None
112
<Priority>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535
Blocking
command has been set, that setting is used.
command has not been set, 128 is used.
(communication interrupted).
Advertisement
Table of Contents
