Table of Contents
Advertisement
protocol
protocol
Sets for protocol VLANs a protocol that distinguishes the VLANs.
Input format
To set or change information:
protocol
To delete information:
no protocol
Input mode
(config-vlan)
Parameters
<Protocol name>
Sets the protocol name of a protocol VLAN. The
when the applicable VLAN is a protocol VLAN. If you want to use multiple protocol
names for a single VLAN, set the command separately for each protocol name used.
1.
2.
Default behavior
No protocol is set.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
To use a protocol VLAN with an IPv4 address or IPv6 address set, you must use this
command to specify the applicable protocol.
Related commands
vlan-protocol
126
<Protocol name>
<Protocol name>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Protocol name set by the
protocol
vlan-protocol
command.
command can be set only
Advertisement
Table of Contents
