Alaxala AX1250S Software Manual page 698

Index
Message
Cannot attach this list because
flow detection mode Layer2-2.
Maximum number of entries are
already defined.
<value1>
Over two entry as an address
family cannot be set.
Specified traffic-shape rate
value is incorrect, or it is out
of range.
system function isn't set.
The different name is already
defined.
The Maximum number of entries
are already defined.
<QOSFLOW_GROUP>
The Maximum number of entries
are already defined.
<QOSFLOW_LIST>
The Maximum number of entries
are already defined.
<QOSFLOW_MAC>
The maximum number of entries
are exceeded.
The sequence number exceeded
the maximum value. Try
"resequence" Command.
The total of WFQ min-rate
exceeded bandwidth of
traffic-shape rate.
674
Explanation
If the flow detection mode is Layer 2-2, the QoS flow list cannot be
applied.
If the flow detection mode is Layer 2-2, an IPv4 QoS flow list can be
applied.
To do so, use the following command:
ip qos-flow-group
command
The entry cannot be added because the maximum number of entries
has already been reached. Delete unnecessary entries, and then add
the new entry.
Another QoS flow list has already been applied.
If you want to apply a QoS flow list, first delete an existing QoS flow
list.
The value of the bandwidth for the specified port bandwidth control is
either incorrect or not in the specifiable range.
The setting is not possible because the
command has not been set.
system function
Use the
An entry cannot be added to an interface for which queue group has
already been set.
The maximum number of applications to a QoS flow list interface has
been exceeded.
The maximum number of QoS flow list remark settings has been
exceeded.
The number of entries for a MAC-QoS flow list exceeds the device
capacity.
The number of QoS entries exceeds the device capacity.
The number of used entries and available entries in the configuration
can be checked by using the
The automatic sequence number has exceeded the maximum value.
resequence
Execute the
The total of the minimum guaranteed bandwidths for the WFQ mode
exceeds the bandwidth of port bandwidth control.
Set the total of the minimum guaranteed bandwidths for WFQ mode
so that the value is equal to or smaller than the bandwidth of port
bandwidth control.
system function
command to specify qos.
show system
command.
command.