Table of Contents
Advertisement
mac-authentication vlan
Sets the VLAN IDs of VLANs to be switched dynamically after legacy mode authentication.
If this command is not set, no VLANs are switched after legacy-mode authentication.
Input format
To set or change information:
mac-authentication vlan
To delete information:
no mac-authentication vlan
Input mode
(config)
Parameters
<VLAN ID list>
Sets the VLAN ID list of MAC VLANs to be switched after authentication.
1.
2.
Default behavior
No VLANs are switched dynamically after legacy-mode authentication.
Impact on communication
If VLANs are deleted by using this command, authentication of authenticated terminals
registered in the VLAN you have deleted is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All MAC-based authentication settings take effect when the
system-auth-control
2.
See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3.
All VLAN IDs you have set must be set for a MAC VLAN.
4.
If at least one of the following commands is set for a Switch, this command cannot be
set:
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For details about how to set
Specifiable values for parameters. Note that the default VLAN (
cannot be set.
command is set.
authentication multi-step
<VLAN ID list>
<VLAN ID list>
<VLAN ID list>
and the specifiable values, see
mac-authentication vlan
VLAN ID = 1
mac-authentication
555
)
Advertisement
Table of Contents
