Table of Contents
Advertisement
-
#1
Set commands for the same interface.
-
#2
When forced authentication is used as the Switch default, set
radius
#3
When forced authentication is used as the authentication method by port, set
aaa authentication dot1x
5.
The forced authentication authorization state is canceled if authentication for the
applicable terminal is canceled.
6.
If either of the following commands has already been set, this command cannot be
set:
authentication force-authorized enable
authentication force-authorized vlan
Related commands
aaa authentication dot1x
dot1x port-control
dot1x system-auth-control
switchport mode
radius-server host
dot1x authentication
The following accounting log data is collected when an authentication
request is sent to the RADIUS server:
No.=82
WARNING:SYSTEM:
(<Additional
RADIUS server.
<Additional
information>: IP
You can use the
show dot1x logging
accounting log.
.
or
dot1x radius-server host
#3
information>)
Failed to connect to
command to check the
<List
name>.
dot1x force-authorized
default group
379
Advertisement
Table of Contents
