Table of Contents
Advertisement
set.)
2.
One IPv4 QoS flow list can be set for one interface. A maximum of 64 filters can be
applied to an Ethernet interface or a VLAN interface.
3.
If a non-existent IPv4 QoS flow list name is set, no operation is performed. The IPv4
QoS flow list name is registered.
4.
The type of configuration commands that can be used varies according to the flow
detection mode. For details, see Table 20-9 List of QoS flow group commands that
can be used.
5.
If a MAC QoS flow list has been set for an interface by using the
qos-flow-group
and then set another list.
6.
When a MAC QoS flow list is to be applied to an Ethernet interface and a VLAN
parameter exists as a flow detection condition, the list can be set if the VLAN ID is
included in settings of the Ethernet interface.
7.
When an MAC QoS flow list is to be applied to a VLAN interface, the list can be set if
no VLAN parameters exist as a flow detection condition.
Related commands
ip qos-flow-list
command, no more lists can be set. Remove the existing list first,
ip qos-flow-group
mac
327
Advertisement
Table of Contents
