Table of Contents
Advertisement
spanning-tree portfast default
Sets the PortFast functionality to be used by default. This command is valid on the access,
protocol, and MAC ports of PVST+, single spanning trees, and multiple spanning trees.
Input format
To set information:
spanning-tree portfast default
To delete information:
no spanning-tree portfast default
Input mode
(config)
Parameters
None
Default behavior
If the
spanning-tree portfast
spanning-tree portfast
default
command does not operate.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
spanning-tree portfast
command has been set, that setting is used. If the
command has not been set, the
spanning-tree portfast default
spanning-tree portfast
181
Advertisement
Table of Contents
