Table of Contents
Advertisement
2.
Range of values:
For details about how to set
Specifiable values for parameters.
remove
<VLAN ID list>
Removes a VLAN from the VLAN list that is set.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2.
Range of values:
For details about how to set
Specifiable values for parameters.
Default behavior
None. If a trunk port has been set by using the
switch port trunk
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
If the applicable interface is set as a trunk port, you must set
, no frames are sent or received through the applicable interface.
allowed vlan
If untagged frames will also be sent and received, you must set the same VLAN ID for both
of the following parameters:
allowed vlan
native vlan
If the ID is not set, the untagged frames on the applicable interface are discarded.
Related commands
switchport mode
vlan
<VLAN ID list>
<VLAN ID list>
command is omitted, communication is impossible.
and the specifiable values, see
and the specifiable values, see
switchport mode trunk
allowed vlan
switchport trunk
command and the
. If you do not set
139
Advertisement
Table of Contents
