<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn ignore llc
isdn ignore sending-complete
Use isdn ignore sending-complete to exclude or ignore the sending complete indication for call
setup.
Use undo isdn ignore sending-complete to restore the default.
Syntax
isdn ignore sending-complete [ incoming | outgoing ]
undo isdn ignore sending-complete [ incoming | outgoing ]
Default
The device checks incoming SETUP messages for the sending complete indication.
The device includes a sending complete indication in outgoing SETUP messages.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
incoming: Ignores the sending complete indication in the incoming SETUP message.
outgoing: Excludes the sending complete indication from the outgoing SETUP message.
Usage guidelines
A sending complete indication in the SETUP message indicates the completion of information
sending or receiving.
If you do not specify a call direction, the command takes effect on both incoming and outgoing ISDN
calls.
The command takes effect only when the ISDN protocol is DSS1, QSIG, or ETSI. For a successful
call setup, you must use the same sending complete indication setting as the service provider switch.
You can execute the command only when no call is present on the ISDN interface.
Examples
# Ignore the sending complete indication in the incoming SETUP message on BRI 2/4/0.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn ignore sending-complete incoming
# Exclude the sending complete indication in the outgoing SETUP message on BRI 2/4/0.
[Sysname-Bri2/4/0] isdn ignore sending-complete outgoing
Related commands
isdn protocol-type
isdn l3-timer
Use isdn l3-timer to set an ISDN L3 timer.
172