Table of Contents
Advertisement
Dataset
6.3
Access
Design Data
62
Metadata
Description
Source
The data storage device where the job is stored.
Date cre-
The date of when the job was created.
ated
The panel is similar to the panel that opens when View & edit data was
selected from the job menu. Refer to "7.2 Accessing Data Management" for a
description of the panel.
The differences are:
All changes done in the data set are applied to the original jobs.
•
For the key New: To create a point/line. New points/lines are stored in the
•
main job and then displayed in the data set.
For the metadata, Source is displayed. The linked job to which the point
•
belongs.
On the 3D viewer page, the points and lines from the linked jobs are dis-
•
played. Selected filters for the data set points are applied.
The Dataset panel can also be accesses by a hot key or a favourites keys.
Choosing a Job
Select Leica Captivate - Home:Tap here to choose design data.
The pages that are always shown are: Points & lines and DTM.
The pages, Road, Rail and Tunnel are only shown if the appropriate app is
loaded.
☞
The design data selected in this panel, are global design data. In the
3D viewer and when using the apps. the global design data will be
overwritten by linked design data from the working job.
Key
Description
OK
To accept the selected job.
Page
To change to another page on this panel.
Fn Settings
To activate or deactivate job selection at the beginning of an
app.
Job Menu - Jobs
Advertisement
Table of Contents
