Table of Contents
Advertisement
Camera view
Scanning
Field
Option
Full dome
scan area
Next step
Next changes to the next panel.
The scan area can be defined on the camera view of the telescope camera and
overview camera. Switching between both cameras is possible.
Description of keys
Key
Description
Next
Available when defining rectangular areas. To accept the
selected point and to continue with the subsequent panel
within the wizard.
Available when defining a scan area manually. To accept the
defined extension of the scan area and to continue with the
subsequent panel within the wizard.
Add
Available when defining polygonal areas. To add the current
crosshair position as a next point to the polygonal area.
Distance
To correct the parallax by taking a distance measurement to
any surface. The crosshair style changes from the coarse
style to the fine style.
Done
Available when defining polygonal areas. To confirm the
defined scan area and to proceed to the subsequent panel.
At least three points must be defined.
Back
To return to the previous panel where the definition mode
can be selected.
Fn Display
To configure the camera view. Refer to "Configuring Scan-
ning".
Description of icons
Icons are available in a toolbar on the right side of the panel.
Icon
Hardware
keys
Description
☞
If scan definitions have already
been defined from the current
instrument setup, the scan areas
are displayed on the Camera page
in Manually Entered Extents. A
new scan area can be defined in
addition to the existing scan areas.
The scan area is the full field of view of the
instrument.
Description
Camera view
To switch to the telescope camera. The style of
the crosshairs changes with the camera in use.
841
Advertisement
Table of Contents
