Leica Captivate Technical Reference Manual page 744

Field
Slope loca-
tion
Use cut and
Use fill
Cut slope
and
Fill slope
On the Hinge offset page:
Apply hinge
offsets
Offset
Height off-
set type
744
Option Description
Left or Defines if the slope is left or right of the
Right hinge point.
Road_079
a Hinge Point
b Left, cut
c Right, cut
d Left, fill
e Right, fill
Check box When the box is checked, a cut/fill is used for
the calculation. During the surveying process,
the system calculates if it is a cut or a fill.
Check only one box to work only with cut or
fill.
Editable field Defines the cut/fill ratio of the slope.
☞
Check box When this box is checked, a horizontal and
vertical offset of the hinge point can be
defined.
Editable field The horizontal offset of the hinge point from
the centreline/reference line.
The vertical offset type for the hinge point.
Absolute The only option available for 2D lines.
Relative to Available for 3D lines.
line or
Relative to
DTM
Relative to Available for Stake: Manual slope. The
surface manual slope is defined by:
grade
Hinge offset relative to the selected
•
hinge reference line
• Hinge height, calculated by using the
hinge offset on the selected surface
grade (left or right selected surface
grade, depending on Offset – or +)
a
b
d
The slope ratio format is defined
as system setting in Regional,
Slope page.
Roads - Road
c
e