Table of Contents
Advertisement
☞
7.3.2
Access
Point ID,
Coordinates page
82
It may happen that a point with the same point ID exists in the job. If the
codes and/or attribute values of the new and the existing point do not match,
a panel opens where they can be corrected.
Editing a Point
In Job name, Points page, press Edit.
☞
If multiple points are selected when Edit is pressed, only the target
height is editable. Editing the target height for multiple points is pos-
sible for TS points of class Measured, Adjusted and None.
The visible pages on this panel depend on the properties of the point being
edited.
It is possible to edit the point ID and for points of Class: Control and Class:
Estimated also the coordinates. Other point-related data is shown in display
only fields.
☞
Changing the point ID of a point, applies this new point ID to all other
points with the same original name, regardless of their class.
☞
Points of Class: Reference cannot be renamed.
☞
Changing coordinates of a point which has been previously used in
other apps, for example COGO, or hidden point measurements does
not update the app results.
☞
An edited point retains the creation value for Time.
Key
Description
Store
To store the changes.
Previous
To display the previous point in the list of points displayed
in Job name, Points page. Available unless the beginning
of the list is reached.
Next
To display the next point in the list of points displayed in
Job name, Points page. Available unless the end of the list
is reached.
More
To display information about class, sub class, 3D coordinate
quality, time and date of when point was stored, instru-
ment source, source and the flag for Linework if available.
Page
To change to another page on this panel.
Fn Coord
To view other coordinate properties.
Job Menu - View & edit data
Advertisement
Table of Contents
