Table of Contents
Advertisement
Alignment Results,
Points page
Settings
45.4.7
Availability
Description
Roads - Road
Next step
Calculate computes the alignment information.
Displayed is information about the calculated alignment information: Horizontal
offset from the line, height difference from the defined line and horizontal off-
set from the centreline.
Key
Description
Store
To store the results. Points are stored in the job together
with the alignment information. The points can be exported
with a report sheet later. The information is the same as if
the points had been measured along the alignment.
Page
To change to another page on this panel.
Fn Settings
To configure if the calculated points are stored with the origi-
nal point ID, a prefix or a suffix.
Next step
Page changes to another page.
The fields and information displayed on the
Settings, Info page. Refer to "Road Settings,Info page".
3D viewer displays all the calculated points against the design data.
Description of fields
Field
Option
Store point
Same point
ID with
ID
Prefix
Suffix
Prefix / suf-
Editable field
fix
COGO Road - Create points
This menu function is available for staking/checking a line/local line.
This function allows creating points by defining a distance between points
along the working line and offsets to the working line.
page are as defined in Road
Description
The same point ID from the selected job is
used when storing to the job.
If a point exists with the same point ID in the
job a warning appears. Choose to overwrite
the existing point or not.
Adds the setting for Store point ID with in
front of the original point IDs.
Adds the setting for Store point ID with at
the end of the original point IDs.
The identifier with up to four characters is
added in front of or at the end of the ID of
the calculated COGO points.
771
Advertisement
Table of Contents
