Leica Captivate Technical Reference Manual page 831

During a scan
Pause and options
before continuing
Define Temp Scan
Interval
Invalid measurements
Scan Segments
Roads - Tunnel
During a scan
Next point: To skip the point being measured and move onto the next
•
profile point.
Profile +: To stop scanning the current profile and move onto the next
•
profile.
• Temp: To enter a temporary scan interval.
It is possible to end the scan once started using Stop. To pause the scan, for
example to allow passing site traffic through, use Pause.
Once the scan has been paused, several options are available before continu-
ing:
Stop: To end the scan.
•
Resume: To continue the scan at the next position.
•
• Manual: To interrupt the current scan so aiming can be done manually and
points added.
Auto: After measuring points manually, press Auto to continue scanning
•
where you finished before pressing Manual.
By pausing the current scan and pressing Fn Temp, a temporary scan interval
can be entered. All scan segments being scanned at the defined temporary
scan interval until the Define Temp Scan Interval panel is reentered and Use
a temporary scan interval is unchecked.
Description of fields
Field Option
Use a tem- Check box
porary scan
interval
Temporary Editable field
scan inter-
val
This process is repeated until the measured point is within the chainage limit
or the maximum number of iterations has been reached.
Invalid measurement situations could occur, for example:
in irregular tunnel surfaces, where the horizontal alignment is formed by a
•
curve with a small radius.
if the end distance or start distance defined in Scan Profile, Scan area
•
page were too large.
If Define a scan task: Scan segment was selected in the Define panel, then
the Scan Segments panel allows creating, editing or deleting scan segments.
Description
If this box is checked, then scanning stops
and any defined scan interval is ignored and
replaced by the temporary scan interval.
How often a point is measured around a pro-
file.
831