Table of Contents
Advertisement
Stake Face Auto,
Points page
Stake Face Auto
836
Next step
Page changes to the Points page.
Select the points to include in the stakeout.
Key
Description
OK
To access the Stake Face Auto panel.
Use
To set Yes or No in the metadata for excluding/including the
highlighted point.
Page
To change to another page on this panel.
Description of metadata
Metadata
Description
-
Displays the name of all points in the selected Tunnel job.
Use
For Yes: The selected point is used for stake.
For No: The selected point is not used for stake.
CL offset
The horizontal offset of the point from the layer centreline.
CL height
The height difference of the point to the layer centreline.
diff
Next step
3D viewer shows a cross section, profile and planar view of the design data at
the selected chainage.
IF
a single point is to be selec-
ted/deselected
multiple points are to be
selected
When Stake face auto is activated, the measurement panel opens. In a loop,
all selected points are automatically staked indefinitely until the measurement
is stopped, or the orientation check is out of tolerance.
Key
Description
Stop
To stop the automatic stakeout.
Pause
To pause the automatic stakeout.
THEN
tap on the point.
click the
icon, drag the stylus in a diagonal
line to make a rectangular area.
Roads - Tunnel
Advertisement
Table of Contents
