Table of Contents
Advertisement
14.4
TS Connection Wizard
- Step 2
14.5
☞
☞
Settings required
Connections - TS connection wizard
Connection Using Internal Radio
Description of fields
Field
Option
Link number
Editable field
Set as
Remote or
Base
Next step
Next and follow the instructions on the panel.
Connection To Leica Legacy and Third Party Total Stations
Once you begin working with the CS always work on the controller! Do not
touch the total station software, excluding turning the laser pointer, laser
plummet or guide lights on/off for some models.
Refer to "33.7 Connection to Other Total Stations" for supported functions.
Before using any Leica Legacy or third-party total station, ensure that the fol-
lowing values are set on the TS:
Instrument
Leica Legacy total station
Description
The assigned channel number.
☞
The radio modules inside the field
controller and the TS instrument
must be set to opposite settings.
Set the field controller to Remote
and TS instrument to Base.
Settings
1. Total station ppm/scale:
•
Atmospheric ppm = 0
Geometric ppm = 0 or scale factor = 1
•
These settings ensure that the correct
coordinates are calculated at the CS. It is
still possible to apply the relevant atmos-
pheric and geometric ppm/scale factor val-
ues. These values must then be set on the
CS.
2. Communication settings:
The communication settings on the TS
•
must match the default parameters for
that particular instrument type as seen
on the CS.
For TPS1000 and TPS1100 instruments:
•
•
set the communication mode to GSI
ensure the TS is in the measurement
•
panel when trying to connect.
159
Advertisement
Table of Contents
