Table of Contents
Advertisement
Add Segment,
Input page
Roads - Alignment Editor
Key
Description
OK
To accept the panel entries and continue.
Inverse
Available when Horizontal distance, Horizontal offset to
centreline or Slope distance is highlighted. To calculate the
distance and angle between two points from the job.
Last inv
Available when Horizontal distance, Horizontal offset to
centreline or Slope distance is highlighted. To select values
from the last inverse calculations.
%/
To switch between h:v, v:h and %(v/h x 100) for the slope
V:H/
ratio.
H:V
Page
To change to another page on this panel.
Fn Settings
To configure the app. Refer to "44.3 Configuring Alignment
Editor".
Fn Reset
To reset all panel entries.
Description of fields
Field
Option
Template
Display only
name
Layer name
Display only
Method
Horizontal
distance &
slope
Horiz & ver-
tical dis-
tance
CL offsets
Slope dis-
tance &
ratio
Horiz dis-
tance &
height
Description
Name of the cross section template to be
edited.
Name of the layer to be edited.
Method to be used for defining the segment.
Using a horizontal distance and slope ratio to
define the segment.
Using a horizontal distance and a vertical dis-
tance to define the segment.
Using a horizontal and vertical offset in rela-
tion to the centreline.
Using a slope distance and slope ratio to
define the segment.
Using a horizontal and absolute height to
define the segment. Only available for tem-
plates with Allow absolute heights for
cross section definition enabled.
733
Advertisement
Table of Contents
