Table of Contents
Advertisement
58.8
Description
Access
Point Results,
Foresight page and
Bcksght page
958
Anytime during the traverse: On the Traverse Data panel, highlight the first
setup then Edit. On the Point Results panel, select Page to reach the
Bcksght page. Fn Design.
Traverse Point Results
Point observation results are displayed on this panel.
Is displayed automatically after measuring all sets from the current setup.
Key
Description
OK
While measuring a traverse: Displays a confirmation window
with traverse measurement options. Otherwise: To return to
Traverse Data.
Add sets
To add more sets while still at the setup. It could be neces-
sary on particular legs of a traverse that more than the des-
ignated number of sets is required. Possibly some of the sets
from the first run exceeded the tolerance limit and must be
disabled.
Sets
To include or exclude measured sets in the calculation of a
foresight point. Check a set to include it into the calculation.
Uncheck a set to exclude it from the calculation.
Close
To set a point as a closing point if not selected before meas-
urement. Or to revert a closing point to a normal foresight.
More
To display additional information.
Page
To change to another page on this panel.
Fn Settings
To configure the Traverse app. Refer to "58.6 Configuring
Traverse".
Fn Edit
To edit point code and annotations.
Fn Check
Available on the Foresight page. To check inverse distances
and closure between the selected point and a point from the
fixpoint job.
Fn Design
Available on the Bcksght page of the initial setup. Refer to
"58.7.4 Creating a Control Point from Backsight by Azimuth".
Traverse
Advertisement
Table of Contents
