Table of Contents
Advertisement
Key
Measure
Measure
Stop
Distance
Store
Near
→ boundry
and
→ surface
Done
Page
Fn Settings
Fn Display
Fn Tools
Fn Connect
and
Fn Discon-
nect
Description of fields
Field
Point ID
968
Description
For GS:
To start measuring the surface point. The key changes to
Stop.
For TS:
To measure a distance and store distance and angles.
For GS:
To end measuring the surface point. The key changes to
Store.
For TS:
To measure a distance.
To store the measured surface point. The key changes to
Measure.
For GS:
To search the job for the point nearest to the current posi-
tion when the key is pressed. The point is selected as the
point to be measured and is displayed in the first field on
the panel. After measuring and storing the nearest point, the
next point suggested is the one which was suggested before
the key was pressed.
Available when Measure is displayed.
To change the type of point to be measured between sur-
face point and boundary point.
To finish measuring.
To change to another page on this panel.
To configure SmartCode and auto point measurements.
To configure what is displayed in the 3D viewer.
Refer to "37 Apps - The Toolbox".
For GS:
To connect/disconnect from the GPS reference data.
Option
Description
Editable field
The identifier for measured points. The con-
figured point ID template is used. The ID can
be changed:
•
To start a new sequence of point IDs
overtype the point ID.
For an individual number independent of
•
the ID template Fn Tools.
Volumes & Surfaces
Advertisement
Table of Contents
