Table of Contents
Advertisement
Add Points To Group
Select Points to be
Added,
Points page
Sets of Angles - TS
Key
Description
OK
To select the checked option and to continue with the next
panel.
Description of options
Option
Description
Measure
When this box is checked, the points to be used for Sets of
points
Angles can be measured.
Use within a
Available when Measure points is checked. To select the
set of
measuring sequence.
measure-
ments
Add individ-
When this box is checked, a design job can be selected. Indi-
ual points
vidual points can be selected from this job. Refer to "Select
from a job
Points - Measure,Sets page".
Add all
When this box is checked, a design job can be selected. All
points from
points from the design job are added to the point group by
a job
pressing OK.
☞
The points are sorted in alphabetical order. To sort points by horizon-
tal angle, check Sort points by Hz angle in SettingsParameters,
page.
Key
Description
OK
To store the points to the group.
Select
To change the setting for the Select metadata for the high-
lighted point.
More
To display information about the 3D coordinate quality, the
class, Easting, Northing and Elevation, the time and the date
of when the point was stored,
Page
To change to another page on this panel.
Fn All or Fn
To change the setting for the Select metadata for all scans
None
at once.
Next step
In 3D viewer, the points from the list are displayed in black. The other points
from the job are displayed in grey.
855
Advertisement
Table of Contents
