Table of Contents
Advertisement
50.6.2
Requirements
☞
Access
Measure Target
Setup - TS
Next step
Page changes to the 3D viewer page.
Multiple backsights
The position coordinates of the setup point are required. The instrument is set
up and oriented to one or more known backsight targets.
For SmartStation, the position coordinates of the setup are unknown and are
determined with GS. The instrument is set up and oriented to one or more
known backsight targets.
For TS and SmartStation, the orientation is determined by sighting to one or
more known target points. Ten target points is the maximum. Only angles or
both angles and distances can be measured. The height of the setup point can
also be derived from the target points.
For information on camera and images refer to "32 Camera & Imaging".
In Total Station Setup, select Setup method: Multiple backsights. Press
OK.
In Choose Setup Point, select a setup. Press OK.
Unless otherwise stated the following panel and description applies to the
setup methods: Multiple backsights, Transfer height, Resection, Orien-
tate to line and Orientate to object.
Key
Description
Measure
To measure and store the distances and angles made to the
control points. After storing the measurement data, the next
point ID in the job is displayed. The instrument positions to
the point if enough data is available.
Distance
To measure and display distances.
Store
Records displayed values temporarily. The target measure-
ments are not stored to the current job until the setup is set.
A distance measurement is not necessary before pressing
Store. After recording the measurement data, the next point
ID in the job is displayed. The instrument positions to the
point if enough data is available and the instrument is
robotic.
☞
The setup method Orientate to object requires
valid distance measurements before using Store.
883
Advertisement
Table of Contents
