Table of Contents
Advertisement
44.5.2
Access
☞
Add PI
720
Key
Description
More
To display information about the length in/out and the
parameter in/out.
Inserting/Editing a PI in a Horizontal Alignment
In Horizontal Alignment, PI page, highlight a PI and press Add or Edit.
☞
A PI can also be selected on the 3D viewer page.
☞
Elements are added after the highlighted PI.
Creating and editing an alignment PI are similar processes. For simplicity, only
the creation of an alignment PI is explained and differences are clearly out-
lined.
Key
Description
OK
To accept the panel entries and return to the Alignment
Editor Menu.
Get point
To apply coordinates from an existing point in the job. Availa-
ble when Easting or Northing is highlighted.
Meas app
To go to Measure and measure a point. Available when
Easting or Northing is highlighted.
Inverse
To calculate the values for the distance and the offset from
two existing points. Available when Radius, Length in,
Length out, Parameter in or Parameter out is highlighted.
Last inv
To recall previous results from COGO inverse calculations.
Available when Radius, Length in, Length out, Parameter
in or Parameter out is highlighted.
Page
To change to another page on this panel.
Fn Settings
To configure the Alignment editor app. Refer to "44.3 Config-
uring Alignment Editor".
Fn Reset
To reset all panel entries.
Description of fields
Field
Option
Easting and
Editable field
Northing
Description
The coordinates of the PI.
Roads - Alignment Editor
Advertisement
Table of Contents
