Finding A Target Point - Leica Captivate Technical Reference Manual

50.8
Description
Access
Find Target
892
Description of metadata
Metadata Description
- The point ID of the measured target points.
Out of limit The Out of limit indicates that the delta value of either
measured horizontal angle, distance or height exceeds the
calculation limit.
Unavailable for Orientate to object.
Use Indicates if and how a target point is used in the setup cal-
culation. Choices are 3D, 2D, 1D and No.
Hz diff Difference between calculated and measured horizontal
angle for the target points. If a target point does not have
coordinates, ----- are displayed. Differences exceeding the
defined limit are indicated by Out of limit.
Distance Difference between calculated and measured distance from
diff the setup to the target points. If a target point does not
have coordinates, ----- are displayed. Differences exceeding
the defined limit are indicated by Out of limit.
Height diff Difference between the known control point height and the
measured height of the target point. If a target point does
not have a height coordinate, ----- are displayed. Differences
exceeding the defined limit are indicated by Out of limit.
Easting diff Difference between control point and measured point, calcu-
lated from new setup coordinates.
Northing Difference between control point and measured point, calcu-
diff lated from new setup coordinates.
Next step
Page changes to the 3D viewer page.

Finding a Target Point

The Find Target panel can be accessed, to guide the prism to the selected tar-
get point.
The panel is only available if the Stakeout app is available on the instrument.
The functionality of this panel is similar to a stakeout routine and is intended
to help find hidden survey bench marks or base points.
Press Fn Find in Measure Target once enough data is available to calculate
roughly the new orientation.
This panel is similar to the Stake Points,
the Stake Points settings. Refer to "Stake Points,page" for a detailed descrip-
tion of this panel.
page and is configured through
Setup - TS