Table of Contents
Advertisement
Coordinate Systems
9.3
☞
☞
☞
Coordinate Systems
3.
Open the selectable list for Coordinate system.
Listed are all coordinate systems stored in the database DBX. Any unavailable
information is shown as -----.
Key
Description
OK
To select the highlighted coordinate system and to return to
the previous panel. The selected coordinate system is
attached to the job.
New
To create a coordinate system manually. Refer to "9.3 Coordi-
nate Systems - Creating and Editing".
Edit
To edit the highlighted coordinate system. Refer to "9.3
Coordinate Systems - Creating and Editing".
Delete
To delete the highlighted coordinate system. Deletion is not
possible if the highlighted coordinate system is active and its
source is RTCM.
More
To display information about the type of transformation
used, the type of heights computed, the number of control
points used for the determination and the date of when the
coordinate system was created.
Fn Set deflt
To turn the highlighted coordinate system into a user-
defined default coordinate system stored in the instrument.
Fn Default
To recall the deleted default coordinate systems.
Coordinate Systems - Creating and Editing
Coordinate systems can be defined by manual creation or determined by calcu-
lation.
In this chapter, the manual creation of coordinate systems is explained. Refer
to "39 Determine Coordinate System" for information on the determination by
calculation.
Coordinate systems with a Classic 3D transformation can be defined by manual
creation.
The type of transformation of the selected coordinate system determines
which elements of a coordinate system can be edited. The name of the coordi-
nate system, the method of residual distribution and the geoid model in use
are always editable.
109
Advertisement
Table of Contents
