Table of Contents
Advertisement
Segment Info - Start
Point/
Segment Info - End
Point,
Vertical alignment
page
43.3
43.3.1
Access
Road Settings,
Quality control page
628
Refer to "Segment Info - Start Point/Segment Info - End Point,Hz alignment
page" for a description of keys.
If a value has not been defined, the field is shown as -----.
Description of fields
Field
Option
Line name
Display only
Chainage
Display only
Easting,
Display only
Northing
and
Height
Grade
Display only
Vertical
Display only
radius
Vertical
Display only
type
Next step
OK returns to the previous panel.
Configuring Roads Apps
Configuration Settings
Select one of the Road apps from the Leica Captivate - Home menu.
In the Task press Fn Settings.
Description
Especially when checking points in an as-built control or when staking out it is
useful to enable the Quality control criteria available. For every point stored,
the chosen parameters are checked and if the check limits are exceeded a
warning is shown. This function guarantees a higher productivity as it is no
longer necessary to check the values for every shot taken. Checking layers of a
road, a layer that is too thick results in higher costs as more material is used.
Alternatively, a too thin layer can lead to problems and could cause serious
damage. Therefore different check limits for above and below the design can
be defined.
Graphic
a
d
b
e
c
Road_087
Description
The name of the selected line.
The chainage of start/end point of the seg-
ment.
The East/North coordinate and height of the
start/end point of the segment.
The grade at the start/end point of the seg-
ment.
The radius at the start/end point of the seg-
ment.
The current segment type.
a
Layer is too thick
b
Design surface
c
Layer is too thin
d
Upper height limit
e
Lower height limit
Roads - General
Advertisement
Table of Contents
