Table of Contents
Advertisement
Measure - Auto Points
Key
Description
OK
To accept changes and return to the panel from where this
panel was accessed.
Content
To configure what is viewed in the
app. Available for Automatically measure points checked.
Page
To change to another page on this panel.
Description of fields
Field
Option
Automati-
Check box
cally meas-
ure points
Measure
Time
new point
after cer-
tain
Distance
Difference
in height
Distance or
height
Distance &
time
Key press
Description
Activates the logging of auto points.
☞
All other fields on the panel are
active and can be edited.
Auto points are logged according to a time
interval. The time interval is independent
from the update interval for the position on
the panel.
The difference in distance from the last
stored auto point, which must be reached
before the next auto point is logged. The
auto point is logged with the next available
computed position.
The height difference from the last stored
auto point, which must be reached before
the next auto point is logged. The auto point
is logged with the next available computed
position.
Before the next auto point is logged, either
the difference in distance or the difference in
height must be reached. The auto point is
logged with the next available computed
position.
An auto point is stored when the position of
the antenna/prism does not move more than
the distance configured in Minimum dis-
tance between points within the Stop
time.
Once a point has been stored, the position
must change more than the distance config-
ured in Minimum distance between points
before the routine starts again.
An auto point is stored upon pressing Meas-
ure (for GS) / Store (for TS) in the Measure
app,
page. In the beginning, the chain to
which the auto points are assigned must be
started with Start. In the end, the chain
must be closed with Stop.
page in the Measure
931
Advertisement
Table of Contents
